pimount-BottomRibbon.stl

This is designed to fit in a Voron or any printer that uses a 2020 Extrusion. Use a T-Nut in the Extrusion, and a M3x12mm hex screw to hold it in place.

To attach to the camera itself I was lazy and used some VHB tape which is plenty strong. I tried a previous mount with standoffs, but they were far too weak and there are so many different versions.

Here is a look at it being used for a timelapse:
https://www.youtube.com/watch?v=NwDJNf_6DmU

And the original video it was featured in where I talk about it some more:
https://www.youtube.com/watch?v=ISUJ79KNBEI

Things needed:
---------------------
* Raspberry Pi Camera (pictured is v2, but any should work)
* VHB Tape: Like [this sheet](https://www.ebay.com.au/itm/Genuine-3M-VHB-Tape-Sheet-Mounting-Adhesive-Double-sided-tape-100mmx100mm/202642842784?hash=item2f2e7464a0:g:5AsAAOSwCs1coz3Q&frcectupt=true) or just a roll of 10mm is fine. It lasts forever.
* M3 x 12mm Screw, anything is fine as long as it fits (at least 10mm I think, you can adjust it in the OpenSCAD file
* M3 T-Nut that goes in the extrusion to hold it in place, they look [like this](https://www.makerstore.com.au/product/spring-loaded-tee-nuts-pack-of-10/)

The only thing I have not figured yet is how to conceal the terrible looking ribbon cable, but some mounted cable ties are working at the moment...


Voron v1.8 Printer of Happiness, co-founder of Ballarat Hackerspace

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

SuperRoach

Achievements

Seedling

pimount-BottomRibbon.stl