Model Proudly display your favorite Lego or Lego Compatible minifigs with this ornament. It's printed in multiple parts to minimize the supports needed. It can be set up to either hang from a string like a traditional ornament, or with a sleeve that slips over a standard mini bulb for a lighted ornament.
To assemble:
Print the ornament front, back, stud connector, and plate holder. You will likely need to use supports on the ornament front. I've found success printing the back “face up” so the smooth back is on the bed, and the front “face up” as well with supports on the interior. If you're using a coextruded multicolor filament be sure to orient the front and back in the same direction so the colors line up.
Print either the two-hole ornament hanger for use with string, or the single hole for use with a mini bulb.
Use your favorite glue to connect the stud connector and plate holder, then glue the assembly into the back of the ornament (just under the bump on the back). Glue the front in place. The ornament hanger screws in so you can change it out as needed.