Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3236889.

Anet A8 X bracket for the X and Z axis.

Contains mounts for the motherboard and power supply.

Overkill design, but made to match the Anet frame

• works great and cleans up the electronics a bit
• might need spacers (1.5 mm) I think I screwed up my X width measurement?
• 5mm spacers are for power supply and motherboard
• Design is broken into 4 for smaller printers like the A8
• A light sanding and gorilla glue super glue hold the beams great in compression and tension.
• Tabs/T-beam point forward
• Full design is also included. -They are easier to sand/glue together if you do not use a brim or any support, just a skirt to start your print works fine.

If you'd like any measurements, additional picture or anything, let me know and I'll see if i can help

Need: P1 P2 P3 P4 5 mm spacer x 8 1.5 mm spacer x 2