ZIP22 AOD v4.stl

Tired of putting your finger directly next to the barrel of your Zip.22 when clearing jams? Annoyed with the small surface area you have to depress the charging rod?

Let me Introduce you to what I call the "Anti-Oopsie Device". The AOD presses over the Zip-Load rod and gives you ample room to pull the bolt back AWAY from the barrel to help minimalize the "oopsie" aspect of the ZIP. TO PRINT: print with the ridge side down and use brim bed adhesion. TO INSTALL: Heat up the AOD with a hair dryer or heat gun, add a drop or two of super glue and press the Zip-Load rod into place. Note: WILL NOT WORK ON THE ZIP-Restrike ROD. IF NO GLUE IS USED, AOD GETS LAUNCHED ABOUT 5 FEET AWAY. ITS FUNNY BUT I DONT RECCOMEND.