This is an LED border for Multiboard. I wanted something that utilized the clips on the side of the board, so I didn't need to use up space on the face with a bolt, like I have seen currently. The board is intended to be used with an 8x8 with offset mounts that are at least 12mm. The groove set for the LED is 10mm and has worked with every ribbon strip LED that I have used with it. I also angled the ribbon 5* towards the wall so it isn't shining in your face.

To make this easier, I would plan to take the mounts off of the board if you can, it makes the LED ribbon installation much easier. I would also use the lite dual clips for assembly.

Also, big thanks to Mike Kovařík for posting the step file for the negative clip profile. Saved a lot of time and filament testing. They worked perfectly the first time around!