tracking pixel
Ruven B

Twister Fidget Toy

by
RuvenBals
Follow
Follow
Remix Model
2D
3D
Makes
instagram-play
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model
Twister Fidget Toy 3d model

You need: 6 Pieces. You can also connect more but, some of the higher configurations are not symmetric.

Print Settings: Standard settings. No supports or any special settings needed.

Assembly: You can just watch this Video: https://youtu.be/yYEv9C052pg The longer End should be pushed into the middle of another Piece. Then build a Ring and that's it. You can take a look at the pictures for guidance.

Pictures by Coco3D Cocos Instagram Cocos Thangs


45 Likes303 DownloadsAugust 23, 2024


45 Likes303 DownloadsAugust 23, 2024

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimNo