Hey, this model is a variation of the Slime Ball I came up with. It feels like a liquid egg dripping down your hands! 😄

Print Settings: Try printing the "Easy to print" version first. No supports, but print it slower than usual.

Slice the Presupported files with standard settings and without supports enabled. The unsupported file should be sliced with supports enabled. This is not an easy print. Print this slow! I print this model at 50% speed.

Support Removal: I made a video that addresses that and troubleshooting. [https://youtu.be/sbAj2lsgoUA)

Troubleshooting: If your egg detaches from the support during the print, then print one of the files in the troubleshooting folder with a closer support. It's about finding the right balance between the support fusing with the model to support it, but not too much to not get permanently fused. You may need to print different files for different Filaments. They all behave differently. If yours does not slide well, try another Filament. If you find a filament that slides well, please comment it so that we can get a collection of good Filament going for this model.

Technical Data: One Slime Ball uses roughly 110g of Filament and takes 8 hours to print on my Bambu A1.