This is the H-Cube. A design that spawned after the creation of my testlement cubes. Whereas those could only attach on the side and were limited to essentially two cubes in height, the H-Cube has no such limitations. It can be stacked infinitely high (in theory). They can be stacked in groups of 5, with 4 on the bottom and one on top to lock in the others locked into the middle hole. They can be stacked with the pongs of one cube pushed into the spaces between the others.

-Essentially, they can make anything if you have enough creativity and cubes.

In the pictures, I show a phone holder I made and a few abstract builds. I will update with more builds once I have had time to print more cubes. #FunctionalArt

🚨🚨🚨🚨🚨🚨

This model is for personal use only. If you want to sell physical prints of our designs, or you want to support us, please SUBSCRIBE TO OUR THANGS MEMBERSHIP PLAN : https://than.gs/u/161490?plans=true

🚨🚨🚨🚨🚨🚨

Print Settings: I recommended using the version with built-in supports with a .12 mm layer height. However, that was with a Bambu x1c, and you might need to use a .1mm layer height if you find your cubes fit together too tightly.