tracking pixel
Protopasta

Mr Fusion Dice Tower

by
Protopasta
Follow
Follow
Remix Model
Protopasta
Protopasta
Image 1 of 4
Mr Fusion Dice Tower  3d model
2D
3D
Makes
Mr Fusion Dice Tower  3d model
Mr Fusion Dice Tower  3d model
Mr Fusion Dice Tower  3d model
Mr Fusion Dice Tower  3d model
This model is restricted by licensing terms. 
88 Likes105 DownloadsMarch 2, 2024
This model is restricted by licensing terms. 


Great Scott! Print your own Mr. Fusion Reactor prop that's also a dice tower!

Gloop and Protopasta merged together to form a special collab for the February Endless PLA Subscription!

Learn more about this collab here: Gloop x Protopasta

Want this model a month early and/or sell this design? Become an Endless Designs Subscriber here: Endless Designs Subscription

Print Settings -.2mm Layer Height -15-25% infill -The Mr. Fusion Base top is a 3mf if you want to print with color -Supports Needed for Lever -Supports optional for bolt holes on the base bottom and top

Assembly -Print all parts -Secure the lever onto the front of the base -Secure the Top to the Bottom using the 10mm nut and bolt -Slide the container into place of the base top -Gently pressure fit the knob onto the back -I found that heating it a bit with a lighter helps because it will want to snap if you press too hard -Press the lid onto the top -Some sanding may be necessary due to printer tolerances


88 Likes105 DownloadsMarch 2, 2024




This model is restricted by licensing terms. 
88 Likes105 DownloadsMarch 2, 2024
This model is restricted by licensing terms.