Holds an ice scoop on the side of your ice maker. This model is a remix/edit of this creator: https://www.thingiverse.com/thing:5196224. I removed the original support bracket, added a chamfer to the bottom of the holder, and rounded over the top edge of the holder.
When I printed it, it was slightly too large but it still worked fine. Depending on the size of your ice scoop, you may find it helpful to scale the model down by 5-10%
I remixed this to work with an igloo ice machine scoop. As long as your scoop is similar or the same size, it will work.
You can affix the holder onto your ice machine with some double-sided sticky tape.
Variable layer height is recommended toward the top of the holder, so the curved edges come out nicely. You could also just print the whole thing at .16 or lower so the layer lines are less noticeable. It is recommended you use PLA or PETG for the model, but other materials would work fine. 15-25% infill will work fine.
This license applies to this file: Creative Commons - Attribution (Same license as the original designers model)