ESP32-2432S032C Case

This is a case for the 3.2" Cheap Yellow Display (CYD). It fits the 3.2" capacative display version but should also fit the resistive one (I don't own the resistive one so I haven't tested it).

I took measurements and inspiration from:

https://www.printables.com/model/832282-cyd-32-case

I liked the design, but it was a bit weak and flimsy. This version brings a bit of extra "chonk" to the table and crisper edges for better prints. I like rounded corners but not bevelled edged...

I printed this with Sunlu PLA+ at 230c with a bed temp of 60c...cooling off for first layer. 100% infill on a Flashforge Adventurer 3. Obviously adjust to the settings required for your chosen material. You don't have to use supports, it should print without, but you might need supports for the cutouts on the sides if your printer isn't very good at bridging.