.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
Frankenstein Hand
Frankenstein Hand 👻
This is a sculpture of Frankenstein's Hand holding a bowl for you to carry when you go Trick or Treating or to hold candy in your home/office, a spooky bowl to decorate your Halloween season.
This model has about 10.5 cm (4.13 inches) in height, and 7.3 cm (2.87 inches) by 8 cm (3.14 inches) but it's resizable.
When you purchase this model, you get: 3mf files to print with multicolor: (open in Bambu or OrcaSlicer) ▪ Frankenstein Hand (Fully Painted).3mf — a file with nails, bolt, and stitches painted, as well as the patches on the bowl. ▪ Frankenstein Hand (Partially Painted).3mf—a file with nails and bolt, as well as the patches on the bowl. ▪ Frankenstein Hand (Not Painted).3mf—a file with just the model and profile.
Stl files: ▪ Frankenstein Hand (Bolts).stl—only the hand with bolts ▪ Frankenstein Hand (no Bolts).stl—only the hand, no bolts ▪ Frankenstein Hand (Bowl).stl—just the bowl ▪ Frankenstein Hand (Full).stl—Hand and Bowl together if you want to print it just in one go. Enjoy this spooky Halloween season! 👻
Happy Printing, and thank you for your support!
Note: The .3mf has the settings/profile for a P1S and created on OrcaSlicer, check if it's needed to be change to suit your printer.
If you want a commercial license for your printed models, you need to be a member of the community on: Patreon: patreon.com/palm3d Buy me a Coffee: buymeacoffee.com/palm3d Thangs Membership: thangs.com/palm3d
Keychain: Kawasaki V
Keychain: Kawasaki IV
Keychain: Kawasaki III
Keychain: Kawasaki II
Keychain: Kawasaki I
Keychain: Jeep II
Keychain: Jeep I
Keychain: Jaguar III
Keychain: Jaguar II
Keychain: Jaguar I
Keychain: Iveco I
Keychain: Isuzu I
Keychain: Fox I
Christmas Boot
Christmas Boot
Candycane Box
Candycane
Santa's Hat Bowl
Keychain: Fiat II
