A Turnstile-like flipper with additional pathing. Check the video to see it in action.

Hardware

• one M3x10 screw (or longer)
• one M2x4 screw (or longer)
• one M3 washer

Assembly

1. Install an M2 screw into the bottom of the base. It must protrude past the floor of the tile.
2. Insert an M3 screw into the flipper, stack a washer on the end of the screw, then install the flipper. It should freely spin and barely wobble.

This tile is part of my Mechanical Flippers Pack. Check the others out.

• 180 https://than.gs/m/1116280
• Alternator https://than.gs/m/1116292
• Bounce Flop https://than.gs/m/1327656
• Follower https://than.gs/m/1228246
• I-Flop https://than.gs/m/1288093
• JL Flop https://than.gs/m/1327657
• Omni-Flip https://than.gs/m/1228247
• Side Flop https://than.gs/m/1116295
• T-Switch https://than.gs/m/1116307
• Trident https://than.gs/m/1228248
• Tri-Switch https://than.gs/m/1288137
• XC Flop https://than.gs/m/1327667