A 180-degree flipper that alternates between allowing 10mm balls and 3/8" balls to pass through, depending on the flipper's orientation. The ejected ball is redirected either down the gutter or out the top. When the text is visible, it indicates which balls can pass. Watch the video to see it in action.

Hardware

• Two M3x12 screws
• One M3 washer

Printing

• Layer change on base for text color, recommended green text.

Assembly

1. Install an M3x12 screw into the side of top of the flipper. It must protrude past the bottom of the flipper.
2. Insert an M3 screw into the center of the flipper, stack a washer on the end of that screw, then install the flipper. It should freely spin and barely wobble. The side screw should not protrude past the bottom of the tile, should provide 180-degree rotational lock to the flipper and should not grind the wall of the base.

These tiles are part of my Sorting Pack. Check the others out. Filter Drop https://than.gs/m/1255155 Filter Jump https://than.gs/m/1255156 Sorter Ramp https://than.gs/m/1255157