A protective hard-shell carry case for the Dbrand Joy-Lock. Slip the Joy-Lock in before chucking it in a bag, drawer or backpack and stop it picking up scratches and dust.

Snap-fit closure — no hinges, no screws, no separate lid to lose. Prints in a single piece.

What's in the pack

1 × STL file (single-part shell with integrated snap closure) 1 × 3MF with my Bambu Lab profile baked in (PLA, 0.2 mm, no supports) Designed to print without supports — just throw it on the plate

Print notes

Print orientation: open face flat on the bed (default in the 3MF) 15% infill is plenty — the shell isn't load-bearing 3 perimeters give the snap-fit edge enough flex without snapping PLA is fine for indoor use; PETG if you want better impact resistance for travel

Compatibility

Designed for the Dbrand Joy-Lock (Switch 2 controller grip) Joy-Cons may need to be detached before storing, depending on your Joy-Lock variant

License

CC BY-NC-ND 4.0 — print for personal use, no commercial reselling of prints, no redistributing or modifying the STL. Credit MuchaLabs if you post pictures.

Tested on Bambu Lab P1S and H2D. Fits any printer with a 200 mm × 200 mm bed.

🧡 Designed and printed by MuchaLabs 📩 Have a custom request? Just drop a message! Don't have a 3D printer? Order printed and shipped from Etsy: muchalabs.etsy.com