Ghoster (Ghost Coaster) (6 Face Designs!)

Ghoster (Ghost Coaster).step

Jack O' Coaster (6 Face Designs!)

Jack O' Lantern Coaster.step

Rear Tube Extension for FF Creator Pro (Old Version)

Rear Tube Extension for the Flashforge Creator Pro (Old Version). Original tube holders didn't hold filament out far enough. These hold it about centered with the Rear Spool Holders also on my dashboard and allows for nice unspooling of the filament.  Fits into the original tube holder mounts on back of printer.

Designed using Fusion360 | M3D Designs - 2021

Rear Filament Spool Holder for FF Creator Pro (Old Version)

Rear Filament Spool Holder for the Flashforge Creator Pro (Old Version). You will need to print two for each side. Original spool holders didn't hold spool out far enough and was a pain to try and fit the spool onto the holders with how I have the printer placed. 

These allow for removal of the spool holder cylinder and easy placement of the spool onto the holders from above or behind - also works with placement onto the holder from either end! Works well with my Rear Tube Extension for the Flashforge Creator Pro (Old Version). 

Designed using Fusion360 | M3D Designs - 2021

Flashforge Filament Holder.stl

Door Handle Casing

Door Handle Casing made to go around some ugly door knobs. You will need to print two. Put them in between the handles before installing the handles and other hardware. Made to work with unknown door handles - may or may not work with your handles.

Designed using Fusion360 | M3D Designs - 2021

Corn Holder

Corn Holder I made to replace a cracked one. You will need two small nails/screws to put into the model. While 3D printing, stop the print halfway when it is printing the cavities and put the nails/screws in. You may need to hold the screws still until it prints over them.

Designed using Fusion360 | M3D Designs - 2020

Canon 67mm Lens Cap (Canon 10-18mm Lens)

Designed this for my Canon 10-18mm Camera Lens. Lens Diameter is 67mm, should work for other camera lenses that are also 67mm. Includes logo for dual-extrusion printing or you can print the lens cover without the logo. 

Let me know if you have any concerns or questions!

Designed using Fusion360 | M3D Designs - 2021

67mm Lens Cap (Cap).stl

M3D Pumpkin 2019

M3D Pumpkin 2019 (Stem)

M3D Pumpkin 2019 (Bottom)

M3D Pumpkin 2019 (Main Body)

M3D Jack-O-Lantern (Light Diffuser)

M3D Jack-O-Lantern V2

M3D Jack-O-Lantern (Scary Face 1)

M3D Jack-O-Lantern (Scary Face 2)

M3D Jack-O-Lantern (Scary Face 3)

M3D Jack-O-Lantern (Roast Turkey 2)

M3D Jack-O-Lantern (Turkey Leg 1)

M3D Jack-O-Lantern (Roast Turkey 3)

M3D Jack-O-Lantern (Roast Turkey 1)

M3D Jack-O-Lantern V1

M3D Jack-O-Lantern (Main Body)

M3D Jack-O-Lantern (Stem)

M3D Jack-O-Lantern (Lid)

M3D Jack-O-Lantern (Blank Face)

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

Maxaye

Achievements

Seedling

Explorer

Up and Coming