MatMire_Makes

Manatee - Articulated Figure

by
MatMire_Makes
Follow
Follow
Remix Model
MatMire_Makes
MatMire_Makes
|
Image 11 of 13
Manatee - Articulated Figure 3d model
MatMire_Makes
MatMire_Makes
|
Image 11 of 13
Manatee - Articulated Figure 3d model
2D
3D
Makes
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
Manatee - Articulated Figure 3d model
This model is restricted by licensing terms. 

Introducing my articulated Manatee design!

These gentle giants frequent coastal waterways, and are also known as by the nickname "sea cow".

This critter prints in two parts. Print the Body and Head, then snap-fit them together. Here's a quick Demo Video to show how it works.

Multicolor 3mf included (works in PrusaSlicer and Bambu Studio)!!

Please, share photos of your makes! I would love to see them!

PLEASE READ: All MatMire Makes Designs are protected under Copyright Law. Your purchase gives you the right to download and print the design for your personal use. You do NOT have permission to resell or redistribute those digital files in ANY way. This includes altered or "remixed" versions of the designs. Prints of the design cannot be sold without authorization.

To sell PRINTS of my designs, you must obtain authorization by joining the "Merchant" Tier of either my Patreon or MMF Tribe

If you like this design, please checkout my Socials and give a follow. More designs are coming soon!

Visit my Amazon Storefront for links to the Filaments & Equipment I used. . . Printing Details:

  • Body: Print-in-Place. No supports needed. There is a small pre-support under the head ball joint. Remove and discard it after printing
  • Head: No supports needed. There is a small custom brim around the head to help with adhesion. Remove and discard it after printing
  • Multicolor 3MF (Compatible with PrusaSlicer and Bambu Studio)
  • 10%-15% Infill (I recommend Gyroid, Crosshatch or 3D Honeycomb)
  • 3 Walls. (Assuming 0.4mm nozzle. Adjust wall count to account for alternate nozzle sizes)

This should generally scale down to about 60% with full articulation, on a well calibrated printer. Your mileage may vary.

*This model was designed for FDM printing. It was not designed for Resin printing, and I cannot guarantee good/functional results. Resin print at your own risk.

Attention: Not suitable for unsupervised play by small children or pets, as small parts can pose a choking hazard if broken off due to rough play. Not recommended for children under 3.


10 Likes6 DownloadsNovember 2, 2024


10 Likes6 DownloadsNovember 2, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

Layer height0.2 mm
Infill density10 %
SupportsNone
Infill styleGyroid