ST-LINK V2 clone end caps

A collection of end caps for the popular and cheap ST-LINK/V2 clone.

To use these caps you have to remove the black plastic around the pins.

There are caps that are meant to be used without removing the pins themselves. The caps actually clamp onto the pins.

The shorter caps are for boards where you have to desolder the pins from the PCB, the cap will then clamp on the PCB (extremely tight fit).

There are also variants with and without a keychain hole.

Be warned that the pins may become easy to break once you remove the original plastic that holds them together. The solder joints are usually not that good. Be careful and proceed at your own risk.