This is a trophy I entered in a contest for an engineering award cerimony. It was made to be 3d printed with SLS which is why its so complicated but im testing it right now on my bambu lab x-1. It surprisingly didnt need a lot of supports. I left a blank face so it would be easy to modify.

NOTES: autogenerate tree supports, 4 walls, inn/outer wall sequence, 25 degree threshold, 15 percent infill gyroid, support on build plate only, critical regions only

11hr print on .5 speed.

P.s. If I wake up to spaghetti I may not update this post but I will try to remember to take a picture and add it to the files

good luck

I had to upload this upside down for it to work so hopefully you can just lay it down on your bed with autolay.