tracking pixel
Layersingreen

Wood Stump Dice Tower

by
Layersingreen
Follow
Follow
Remix Model
Layersingreen
Layersingreen
|
Image 1 of 7
Wood Stump Dice Tower 3d model
Layersingreen
Layersingreen
|
Image 1 of 7
Wood Stump Dice Tower 3d model
2D
3D
Makes
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
Wood Stump Dice Tower 3d model
This model is restricted by licensing terms. 
1 Likes0 DownloadsSeptember 2, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimNo
Infill styleGyroid

A fun mini dice tower! Its mossy, little mushrooms sprout from its trunk, and a hollow in which dice may roll onto a small rocky platform.

at 100% you can roll D20 dice, can be scaled down to 90% with dice still fitting

Important to note that at 100% scale the platform that catches the dice is not large enough to roll all of the dice one after the other as it s meant to be a mini dice tower for single rolls. There is however room to scale it up some

This dice tower is part of a bigger pack released on patreon, follow the link below to check out the rest of the pack!

This model is for PERSONAL USE ONLY, if you want a commercial license and access to more awesome models you can get it on my patreon https://www.patreon.com/Layersingreen

3D printing settings Prints without supports!


1 Likes0 DownloadsSeptember 2, 2024




This model is restricted by licensing terms. 
1 Likes0 DownloadsSeptember 2, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimNo
Infill styleGyroid