Jam clicker 🍑

• 3 walls, 15% gyroid or 3D honeycomb infill, no supports

• Don't scale the clicker

• I most commonly use kailh switches they have a nice crisp click sound! I buy them from amazon

• Ive included a guide on the clickers in the zip

• Ive included a Tolerance test for the top of the jar. Your tolerance will vary between different flow rates making the top tighter fitting or looser. Make sure to run the tolerance test before printing the tops. Depending on the result I recommend scaling up or down by 0.5%

• Ive included a flat clicker, and a jelly one!

• Make sure the two metal prongs on the switch are straight when putting in the switch or cut them off carefully away from your face as they sometimes go flying in all directions. Do not bend them.

Jam Paperclips

• 3 walls, 15% gyroid or 3D honeycomb infill, no supports

• The paperclip jar is a little bigger than the clicker jar so the tops cannot be interchangeable

• Tolerance test for the top included

• Jar fits 4 paperclips

Editing 3MF

Please note that 3MFs will load with a custom profile that I used to print these models. Double check your settings prior to printing + + ⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐

📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available on my profile page - Click here📌