✨ Woobu Upa ✨

3 walls, 15% gyroid or 3D honeycomb infill. No supports.

The print in place version tested down to 50% I don't recommend going below 70%

for the split to parts version Use 0.12 Layer height for best quality on everything except the body which can be printed with standard 0.2 layer height

Use Concentric pattern for top surface pattern

Split to parts version tested up to 120%, I don't recommend scaling this version down

Please use Brims with a brim gap of 0.3 if you are using Textured PEI plate, especially so if its a multi color plate. A little bit of post printing clean up is better than losing the plate due to adhesion issues.

For the split to parts version tolerance can vary across printers and filaments, Scaling up or down 2% depending on your fit should resolve any assembly issues. If you need to scale the face make sure you are also scaling the rest of the face parts with the same scale.

I've included a fish magnet for the magnet faceplate. The magnets required are 5x3 and I get mine from amazon!

create a pause on layer 20 when printing the hidden magnet fish version to insert the magnets.** Please don't use this version if you don't have a magnetic build plate, without a magnetic plate the magnet will stick to the nozzle and could result in damages. **

Editing 3MF

Avoid using the slicer's fill tool when coloring the eyes, and faceplate in the 3MF files, because they are split to parts. Instead, assign color to them from the object list to make the edges look cleaner. Do not split to objects. 



Please note that 3MFs will load with a custom profile that I used to print these models. Double check your settings prior to printing.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐ + + 📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available from my profile page - Click here📌