🕸️ Spooky Clicker pack 🕸️

• 3 walls, 15% gyroid or 3D honeycomb infill, support free

• I get my Switches (the part that clicks) from amazon. The listing is from Canadian amazon: Kailh box Jade switches

• I recommend putting your keychain chains in first before assembling the clicker

• Depending on your tolerance you may find the switch to be too loose or too tight, I recommend scaling 0.5% down or up to make for a better fit. Adding a tiny bit of superglue to the base and to where the switch connects is also another way to secure the clickers. Careful as to not glue the switch shut.

• Cutting the metal tabs on the bottom of the switch is not necessary but if you are not gluing in the clickers i do recommend carefully removing them as they are sharp.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐
 + + 📌These models are for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available on my profile page - Click here📌