✨ Sakura ✨

• 3 walls, 15% gyroid or 3D honeycomb infill. No supports.
• Tested down to 50%. I don't recommend going below 70% for both versions.
• When scaling you may need to adjust the scale of the wings, if your wings are loose at 70%, scale them up 2%. I had to scale the 150% wings down 2% to help them fit easier.
• Please use Brims with a brim gap of 0.3 if you are using Textured PEI plate, especially so if its a mulitcolor plate. A little bit of post printing clean up is better than losing the plate due to adhesion issues.

Editing 3MF

• Avoid using the slicer's fill tool when coloring the eyes and eye shines in the 3MF files, because they are split to parts. Instead, assign color to them from the object list to make the edges look cleaner. 



• The eye shines can be deleted by holding alt and clicking on them in prepare tab, then right clicking and choosing delete from the drop down.

Inserting wings

Youtube short with inserting the wings - Youtube shorts

• When inserting hold the wing closest to the ball end to help stabilize it during insertion, gently nudge ball joint back and forth while pushing it into place

• you should be able to dangle the dragon from the wings without them falling out

• If wings are loose increase wing scale by 2%, if they are difficult to insert scale down by 2%

I have Included the castle in this release. 100% sakura fits into 100% castle.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐
 + + 📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available from my profile page - Click here📌