I've got something a little different today for valentines day 🫣

The "plug" for a lack of a better term is the male part where the two prongs fit into, I recommend adding a bit of glue to make sure they stay put. The socket is the female part! They do have a difference in tolerance sizes of the holes, the plug has a tighter tolerance than the socket, so make sure you are fitting the prongs into the correct part which is the plug

If you are finding it difficult to fit the prongs into the plug its likely just a tolerance issue, try scaling it down 1% if they don't fit and up 1% if they are too loose. Make sure to test the fit first if you are planning on printing many at a time.

I included a plain set and one with hearts. 3MF files included. No supports!

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐ + + 📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available from my profile page - Click here📌