Its an 8 bit axolotl or a Bloxlotl!

I have included a tadpole version as well as prepainted 3MF files!

These guys make great end of roll savers, I also print them as purge objects ( 50% rectilinear works best to eat up the most waste using bambu slicer)

Tested down to 80%

The big green yellow guy is 220%, the purple teal are 100% and the yellow spruce tads are 80%

Make sure you have good amount of infill to supports the top layers! I personally use 15% grid on the bambu slicer!

This model is for PERSONAL USE ONLY, if you want a commercial license and access to more awesome models you can get it on my patreon https://www.patreon.com/Layersingreen

3D printing settings No supports! I only used supports on the 220% one just so the eyes don’t droop! I used the normal default supports in bambu slicer, make sure you enable “on buildplate only”