tracking pixel
Kazi T

Electribe 2 voronoi stand

by

Kazi Toad

Follow
Follow
Remix Model
Like
Kazi Toad
Kazi Toad
Image 1 of 3
Electribe 2 voronoi stand 3d model
2D
3D
Makes
Electribe 2 voronoi stand 3d model
Electribe 2 voronoi stand 3d model
Electribe 2 voronoi stand 3d model
This model is restricted by licensing terms. 
0 Likes7 DownloadsDecember 13, 2021
This model is restricted by licensing terms. 


These files are for Personal Use Only. If you would like a Commercial License to sell prints made from these designs, please join me on Patreon: https://www.patreon.com/kazitoad

This custom voronoi stand is made to keep the Korg Electribe Sample (or Electribe 2) propped up at a nice 12 deg angle and look good while doing it.

One of the "mid" pieces has an integrated cable holder for the power cable and some headphones. The "left" has a cutout to access the SD card and USB port and the back is completely open to allow for cable access. All of the pieces are positions to keep the bottom facing LEDs open.

If you would like to replicate this stand you should print 3x "mid", 4x "spacer", 1x "right" and 1x "left" STLs. To assemble all you have to do is skewer the pieces with 2x M4 threaded rods of 360mm length and cap them with nuts and washers. This design is somewhat modular so it could be used for a number of other synths of various dimension.


0 Likes7 DownloadsDecember 13, 2021




This model is restricted by licensing terms. 
0 Likes7 DownloadsDecember 13, 2021
This model is restricted by licensing terms.