2D3D
Makes
Be the first to upload a Make
Magnetic Glock Mag Holder
Rotate 180 degrees such that no support would be required on the side with the countersink holes
Estimated time: 3h 15min
Nozzle size: 0.4mm
Estimated weight: 29g
Material: PLA
Layer height: 0.28mm
Infill: 15-25%
Support: Yes (Only for largest hole)
Raft: No
Additional Material: -2 x M5 screws / two way tape -22mm (diameter) magnet
Post Printing: -Super glue the magnet in the middle hole at the base -Attach to a surface either using the screws or two way tape
Category:
2 Likes8 DownloadsSeptember 30, 2021
2 Likes8 DownloadsSeptember 30, 2021