This model is restricted by licensing terms.
View license.
A little print in place container concept with a rising inner box I've been working on and plan to build upon further.
To make it a bit more useful, I designed a small separate attachment you can add to make it pop… See it in action: https://youtu.be/_wPec0dZNh8
After printing, push the lids up at the same time and push the inner box down until the built in supports come out.
Remove the supports and you're good to go.
If you print the ring attachment, I recommend PETG.
Category:
159 Likes501 DownloadsJune 2, 2023
159 Likes501 DownloadsJune 2, 2023
This model is restricted by licensing terms.
View license.