Cube wave - a side table
751 downloads · 2 years ago · Build yourself a sleek and minimalistic side table consisting of two identical pieces stacked on eac
This model is restricted by licensing terms.
View license.
Build yourself a sleek and minimalistic side table consisting of two identical pieces stacked on each other. The waveform pattern enables a perfect positioning without the need for additional mounting hardware.
**Size: ** 240 x 215 x 240 mm 2 pieces add up to 400mm in height 1 "middle half" adds 120mm 1 "middle" adds 200mm
As the pieces are really big I recommend using a 0.8mm nozzle and go high in terms of the layer height. Consumes about 800g per piece. Position the seam in the waveform region.
Recommended settings: 0.8mm nozzle 0.56mm layer height 1 wall 10% gyroid
Cube wave - a side table
751 downloads · 2 years ago in and
This model is restricted by licensing terms.
View license.
Orsa - a floor lamp in scandi style
Habo floor lamp
Swing retro pendant
The Honey shelf system
Ikea Fado rumbler (25cm version)
Venio - a futuristic table lamp
Borno vase
Cibol - a table lamp
Rocket side table
Umea industrial - a floor lamp with steel/copper/aluminum pipes
Funnel vase two parts
Hobbs - a levitating desk lamp
Dego - a modern cup shelf
Needle vase - minimalistic & elegant
Needle bowl - an elegant & minimalistic bowl
Coneo - a space age housing for Ikea Fado (17cm)
Cup shelf wave
The Y Stand for IKEA Fado (17cm)
Kami - a floor lamp in boho/scandi style
are the cylindrical legs printed separately and stuck on with glue / double sided tape?
Hi I really like the table but I had one question. How do you prevent the modules to move from the front and back over each other? I haven’t printed it yet, but before printing I was wondering if that might be an issue. I will be printing a big piece under and top, and two smaller in the middle.
I have a bambu lab X1 and keep getting "body is too close to exclusion area, there may be a collision when printing". I have been repositioning it for a while. Is this calibrated for bambu? if not how can i make sure it prints properly
Hey, Bambulab has a small rectangle in the front left corner where you cannot print because of the filament cutting mechanism, make sure the part does not interfere with that area...
how do I do that. Is it possible to still print this item with the printer I have?
Yes sure. I have the same one. Just make sure the model does not interfere with the gray marked area in the front left corner. Maybe you can try auto-orient with rotation on