Skull lighting

This Halloween item is a skull light. Most 3D printed skull lights are not very bright as lights, as most of them only leak through a hole. So, I came up with a design using the vase mode to print as thin as possible.

Since the slice setting is important for vase mode printing, be sure to check the slice setting uploaded together.

1. After printing, the support must be cut and removed.
2. Fold the pin attached to the head cap into the hole where the support was removed and insert it into the hole.
3. Finally, simply insert the handle into the hole in the head cap.
4. The light used is an LED tea candle light. All you have to do is open the skull's head cap, put this LED tea candle light inside, and close it.
5. Even without LED lights, it creates a spooky atmosphere for Halloween.

Happy Halloween with these skull lights.

Largest part in printing, size = X 180mm, Y 89mm, Z 112mm Design by GOODesign