In response to numerous requests from customers, I designed the F-22 Raptor for 3D printing. The main features are:
- The missile hangar can be opened and closed.
- The angle of the wing flaps can be changed.
- The angle of the horizontal tail wings can be changed.
- The angle of the thrust vectoring flap at the rear of the engine can be changed.
- Landing gears can be equipped.
Precautions to be taken when printing and making are as follows:
- When printing wings, it is recommended to use a brim so that it does not fall off the bed during printing.
- If the brim is not cut accurately, the parts may not fit well, so please remove the brim carefully.
- The flap of the main wing is not designed to move, but is designed to be attached to the user's desired angle.
- Hold the thrust vectoring flap at the rear of the engine with pliers and turn it into place.
1 : 72 Scale Largest part in printing, size = X 93mm, Y 130mm, Z 132mm, After full assembly size= X 194mm, Y 263mm, Z 73mm
Design by GOODesign
Categories:
0 Likes0 DownloadsNovember 6, 2024