This is a 1960s style Mid-Century Modern starburst projection lamp created by Eskimo Pie Studio. It features a print-in-place shade and print-in-place base. Simply glue a sunset lamp in the center of the base. The slot in the edge of the base will allow a cord to pass through. Then simply set the shade on top and you are done. It creates a beautiful projection of a starburst on the ceiling above it and creates a warm glow. I used translucent orange PETG to create the shade and white PLA for the base. The base and shade are already positioned properly in the model files.

3D printing settings

0.2mm resolution

The shade requires no supports. A brim may be needed depending on your setup.

The base requires minimum support and mostly for bed adhesion and a brim of 8 to 9 mm. Tree/organic recommended. You may need to rotate the base so the slot points to the bottom left bed corner. Removal after print completion will be required but takes very little time.