Colin R
Colin R

Light Up Snowman

by
Enique3d
Enique3d
Enique3d
Enique3d
|
Image 1 of 9
Light Up Snowman 3d model
Enique3d
Enique3d
|
Image 1 of 9
Light Up Snowman 3d model
2D
3D
Makes
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model
Light Up Snowman 3d model

Light Up Snowman

Light Up Snowman. This light up snowman, uses Bambu LED kit 001. or similar 6cm led puck. All parts print separately. i would advise to print all parts on the same printer. Dependent on your printers tolerances the parts maybe tight or slightly loose. I've gone for a mid range tolerance, if tight they will clip in, if a little loose you may need a dab of glue. The base with the led puck screws and clips in. 0.2 layer. 10-15% infill. There are some very small parts p[lease ensure good adhesion. im using bambu super tack plate and had no issue printing. on a texture pei plate i would suggest a little glue. Avoid a brim if possible as it will be hard to get the brim off and then the part fit in the slots. There is also a non light version i will upload shortly.


2 Likes5 DownloadsNovember 28, 2024
This model is restricted by licensing terms.