Light Up Snowman. This light up snowman, uses Bambu LED kit 001. or similar 6cm led puck. All parts print separately. i would advise to print all parts on the same printer. Dependent on your printers tolerances the parts maybe tight or slightly loose. I've gone for a mid range tolerance, if tight they will clip in, if a little loose you may need a dab of glue. The base with the led puck screws and clips in. 0.2 layer. 10-15% infill. There are some very small parts p[lease ensure good adhesion. im using bambu super tack plate and had no issue printing. on a texture pei plate i would suggest a little glue. Avoid a brim if possible as it will be hard to get the brim off and then the part fit in the slots. There is also a non light version i will upload shortly.