Cupcake Clicker. This does require and extra part, it uses a standard keyboard clicker. they can vary a little but make sure it looks like ive pictured but for reference the one i used is a standard keyboard switch which can be found on amazon, i’ll link what i used here https://www.amazon.co.uk/dp/B0C6K8H3SD?ref=ppx_yo2ov_dt_b_fed_asin_title. Included are both a multicolour sprinkles top and a plain top. The top does require supports. just around the outside. So use manual supports and paint the outside. the inner part of the top does not require supports. In fact id advise not to as the centre can be impossible to get out. Set top z to 0.3 for easy removal. after removal apple a little heat around the edge and run your finger round to smooth. You could add a brim if you like just for the centre piece but if you have good adhesion its not needed. 0.32 layer. 10-15% infill. Ive used all bambu filament, basic, gradient and marble for the base.