Remix of Post Cap by 3dprintingworld #OutdoorThangs Additional model used https://www.thingiverse.com/thing:2522404/files Remixed the top to allow a screw in topper attachment. There is also a channel for water to escape the hole if a topper is left off. A Volleyball in this case. A perfect edition to your deck for your Volleyball fanatic. 4 sizes available: 75mm (3 in), 100mm (4 in), 125mm (5 in), and 150mm (6 in). This is the size of the ball not the overall size including the screw. The screw adds 10mm to the Z height. Printed with .2mm layers. Support are needed for the ball topper, just the bottom. For the ball topper I suggest 3 walls and 10 % infill if using a .4mm nozzle. Make the top and bottom to match the wall thickness too. Picture has the 100mm ball. The lines on the model are better than how they look in the REF ONLY file.