tracking pixel
DaddyWazzy_TheCreator

Plaque standoffs

by
DaddyWazzy_TheCreator
Follow
Follow
Remix Model
DaddyWazzy_TheCreator
DaddyWazzy_TheCreator
|
Image 3 of 4
Plaque standoffs 3d model
DaddyWazzy_TheCreator
DaddyWazzy_TheCreator
|
Image 3 of 4
Plaque standoffs 3d model
2D
3D
Makes
Plaque standoffs 3d model
Plaque standoffs 3d model
Plaque standoffs 3d model
Plaque standoffs 3d model
This model is restricted by licensing terms. 

Plaque standoffs I attach these to the back of a plaque I print. This gives a little space between the wall and the plaque, as well as giving a place to attach a wire or string for hanging. I use Gloop to affix them. 4 gives the plaque stability but 3 would work too depending on the size of the plaque. 2 are 2mm shorter, these are for the top. Adjust if needed. Picture only shows 1 size.


21 Likes20 DownloadsSeptember 17, 2023



21 Likes20 DownloadsSeptember 17, 2023
This model is restricted by licensing terms.