This model is restricted by licensing terms.
View license.
I designed this from a few diamond's overlaid on each other. Then had fun with the formation. Vase mode print, make sure to use that mode in your slicer. Prints without supports and I recommend at least 1mm walls. I print with a .6 nozzle and use 1.2 line width. This give the vase 2 walls while in vase mode. I hope you enjoy this model DWTC
Categories:
21 Likes22 DownloadsApril 28, 2023
21 Likes22 DownloadsApril 28, 2023
This model is restricted by licensing terms.
View license.