If your mesh door keeps falling out of the track it may because your door did not come with a top track such as mine did. This print will fix that.
Print up to as many as you need then put glue on the back and slide them into the top track slot.
Each individual piece is 200mm in length. if you want a shorter one then you can use a plane cut.
DO NOT SCALE THIS MODEL!! Print Settings
Printer brand:
Prusa
Printer:
I3 MK3S
Rafts: No
Supports: No
Resolution: .2 or less
Infill: 10-15%
Filament brand:
ANY
Filament color:
ANY
Filament material:
PLA, PETG, ABS
Notes:
Print with 3 or four Perimeters/Shells Print with the T upside-down, so that bed adhesion and no supports.
PROTECTED UNDER: Sliding Mesh Door FIX byConn22_43is licensed under theCreative Commons - Attribution - Share Alikelicense.