Wall Mount to use with various Lego Star Wars TIE models. Tested with sets 75211(Solo TIE Fighter) and 75348 (Mandalorian TIE Interceptor) Gives enough clearance to rear for Solar Arrays of both models tested.
Makes use of a Head piece from MroznyHipis Modular Display Stands to give a slight angle to the models display (1.Head - 1Brick 8-0 - Interceptor) Also requires a 2x4 flat Lego plate to connect to bottom of TIE Model.
Print 1x wall mount piece and 1x Head piece per model.
Print wall mount with longest edge face down. Printed in PETG with 0.6 Nozzle at 0.3mm layer height. 4 Shells. Support recommended for screw hole.
Head Piece fits into slot on top of wall mount, Superglue to secure. Also recommend gluing the 2x4 plate to the head piece while you've the glue out.
Secure to wall with via appropriate fixing of your choice via screw hole in rear of wall mount.
Can also be used by ignoring Head piece and gluing Lego plate onto slot on Wall Mount but gives a much flatter flight angle to Model that doesn't look as good in my opinion.