SPINNER | Print-in-place fidget hand spinner

SPINNER | Print-in-place fidget hand spinner

Here is a 100% print-in-place fidget spinner to relieve you from all stress, as if staring at your 3d printer wasn't enough. Come on, we've all done it.. "one more layer and after that, I swear, I'm gonna go to bed!"

Tolerance is key, so I made 3 STL files, one for each of the following tolerances:

• 0.2mm (the one I printed and in the video)
• 0.25mm
• 0.3mm.

Pick the ones that'd work best for your printer,

The 0.2mm one works fine but you'll have to wiggle the bearings a little to get them unstuck. And adding a little lubricant helps too (I applied the grease I use for the 3d printer).

Happy printing!

DIMENSIONS | Ø 90mm x H 8 mm

Printing | ~1.5h

3D PRINT SETTINGS Print-in-place flat on the side, 100% without supports or need for adhesion brim.

Resolution: 0.1~0.15mm / layer

Build adhesion type: None

Supports: None

Infill: gyroid 30~50%