Cant find a pre-existing model for your device? Build your own shelves and use hook and loop tape to attach your device instead! These shelves stand tall enough to pass cables underneath while providing room for taller devices so you can still close the door.
You can also disassemble them and reconfigure as needed!
You will need:
- M2.5 Cap Head Screws, up to 8mm in length
- Industrial Hook and Loop (Velcro Industrial tape is what I use) to attach devices to the shelf.
- Leviton 47615-NYL Push-Lock pins or Legrand On-Q 363729-01 "Grommet Plunger" Push-Lock pins to attach the shelf to the SMC's mount holes.
Notes:
-
These shelves are very strong when printed in PLA+ or ABS. I included more holes for adding more screws if you must attach heavier devices. I found that they seem to do just fine with one screw per foot as the aligning nub provides lots of surface area for binding the foot to the shelf.
-
I recommend to always use the hooks side of the tape against the shelves so you can easily reconfigure the SMC in the future if needed.