Don't know where to store your candy? This has got you covered!

Plus you can store your pens, post-its, and paper clips in there, too. So I guess that might be a good reason to print it, too.

Update October 31, 2025: Added plain top in case you don't want anything on top

Printing Instructions: The 3mf file provided was created using Bambu Studio and should have the following settings already configured.

• Layer height: 0.2mm
• Supports: None
• Brim: Advisable, but not required

Assembly: Please refer to the provided assembly guide. There are places where you can stick rubber feet on the bottom so it doesn't slide around. These are the ones I purchased for the model.

Thank you for your time and consideration on this matter.

Feel free to join my discord for additional support, questions, or suggestions!