_v1.png&w=256&q=75)
The "Flute" Wall Planter
40 downloads · 1 year ago · Flute Wall Planter
***
**Supports**
Two Color Version: On mounting bracket only (Tree supports work
This model is restricted by licensing terms.
View license.
Flute Wall Planter
Supports Two Color Version: On mounting bracket only (Tree supports work great) Single Color Version: Non Needed!
Recommended Print Settings Layer Height: 0.2mm Wall Loops: 2 Infill: 15% (adaptive cubic - for faster prints)
Pictured Size: 3.5" interior pot size diameter
Filament used
Bambu Lab Matte PLA
Colors: -Terracotta -Carmel -Marble
Supplies Medium Command Strips and Screws / Anchors can be found on our Amazon Storefront.
The "Flute" Wall Planter
40 downloads · 1 year ago in and
This model is restricted by licensing terms.
View license.
Desk Cable Holder
Universal Charging Tray
DeskClamp Headset Attachment
DeskClamp Controller Attachement
DeskClamp Hub
The "Verdant" Wall Planter (Improved Design 2025)
Christmas Ornament Hollow Slices
Hallow Christmas Tree Slices with Star! ⭐
Hallow Christmas Tree Slices
Snowman Slices
MagSquares - Starter Set
1x1 Storage Lid - MagSquares
Pencil Cup - MagSquares
1x1 Pencil Lid - MagSquares
1x1 Charge Square - MagSquare
Note Card Square - MagSquares
Battery Inserts - MagSquares
1x1 Phone Square - MagSquares
Magsafe Phone Stand
Will this only be the 3.5" model or will there be the smaller 2.5" and larger 4.5" as well?
the 2.75" has already been added. No 4.5" for this one.
It imports as one large looking object on one plate and Bambu Studio 1.10.2.76 pops up a dialog for either 3mf file "This file contains several objects positioned at multiple heights. Instead of considering them as multiple objects, should the file be loaded as a single object having multiple parts?" I said no and then was able to separate them into separate objects/plates. Wondering if it was intended to be one large all-up object print or should have been separated already?
No you were correct to separate them. The top and bottom should print separately.
Sam, I am struggling with getting this print up to a minimum $3 pph on 3DPrintForce. I am not sure what I have done wrong, but the calculations I have are saying that I need to list the item for over $50. That seems WAY too high for what I printed.