This is a complete redesign of the Rolling Storage Box.
This redesign is much much larger and includes many of the updated features that were added to older versions of the Rolling Storage Box.
Printing
All parts can be easily printed without supports.
Assembly
- Assemble all 6 regular bins, 1 start bin, and 1 end bin by inserting 7 long hinge pins.
- Use 14 hinge caps to lock the hinge pins in place.
- Add 4 3mm x 6mm cylinder magnets to the start and end bins.
- Slide the lock ring into the front core. Glue or bolt using 4 short M3 bolts.
- Make sure the lid locks onto the front core easily. If it's too tight, loosen the lock ring.
- Join the front core and back core. They are a tight fit, so glue should not be necessary.
- Attach the bins to the core by sliding the core onto the start bin.
- Roll the bins around the core.
- Insert a ribbon of strip of velcro into the horizontal slot in the end bin. Use a flat screwdriver to push the ribbon/velcro in.
- Glue is usually not needed.
Can I sell copies of this?
Yes! This project was shared under the Creative Commons - Attribution license.
This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.
Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.
This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.