Gridfinity Hakko 599B Holder

The perfect way to stash the sturdy and inexpensive [Hakko 599B brass tip cleaner](https://amzn.to/3XTwi1Q) on your favorite Gridfinity baseplate. Combine with a soldering stand and wire dispenser for a full soldering station!

To assemble, first remove the feet from the 599B's base to expose the three holes. Insert into the recess so the pegs mate with the holes. For a permanent fit, peen the pegs over with a soldering iron or other hot thingy.

Magnets or screws are VERY STRONGLY RECOMMENDED! You don't want to spill solder dust all over your project!!

Directions:
1. Print one Main Unit and two Sili-Jar Holders from any rigid filament.
2. Take one of the silicone jars apart. Put the lid on the small dish atop the Main Unit to create a screw holder.
3. Cut an X in the bottom of the jar and mount it to a Jar Holder. It will fit snugly in the recessed rim.
4. Take another jar apart and discard the lid. 
5. Completely cut out the floor of the jar bottom and mount to the other Jar Holder.
6. Glue the Jar Holders to the Main Unit. The X goes in the high position and the other goes in the lower position. The floor of both jars face upward.
7. ADD MAGNETS OR SCREWS!!
8. Solder.

Magnets or screws are mandatory for safety. A baseplate is integrated into the stand for more surface area and to manage the center of gravity.

Gridfinity is the ultimate organizer for your whole workshop! Learn more at

Find more Gridfinity accessories at https://bit.ly/3E2NxnZ

Fusion source file: https://a360.co/3Vuk7H6

Gridfinity Tips!

All storage blocks are compatible with all baseplates!
You can add [6x2mm magnets](https://amzn.to/3UuuJV9) to the corners!
You can also use [M3 screws](https://amzn.to/3VRrS9T) to secure the corners.

Gridfinity Miniware DT71 Charger and Dock

The [Miniware DT71](https://amzn.to/3gWPueo) is a full-featured multimeter in a pair of tweezers. Problem: You have to disassemble it to charge it, and it doesn't stand upright in a 42mm³ grid.

Restore order to the Universe with this handy dock. It holds the DT71 assembled or stripped, as well as spare probes. The USB adapter is positioned to use while docked, or stashed safely, with the USB port exposed for charging.

Magnets or screws are VERY STRONGLY RECOMMENDED! Your new tweezers will fall like an old geezer!

Fusion source: https://a360.co/3Urqgm1

Gridfinity is the ultimate organizer for your whole workshop! Learn more at

Find more Gridfinity accessories at https://bit.ly/3E2NxnZ

Gridfinity Tips!

All storage blocks are compatible with all baseplates!
You can add [6x2mm magnets](https://amzn.to/3UuuJV9) to the corners!
You can also use [M3 screws](https://amzn.to/3VRrS9T) to secure the corners.

circuits

Most Downloaded of All Time

Categories

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Gridfinity Hakko 599B Holder

Gridfinity Miniware DT71 Charger and Dock

MotoGP 2024 Circuits Wall Plaque