Extraction Pipe Fitting

This is potentially quite specific to a Weedo M2 (and potentially Weedo F150) 3D printer. There is a fan which extracts ait from the enclosed printer through a filter, but I wanted to have more control of where the output went. I therefore put this convert together which wraps around  an 80cm fan outlet (and its filter cover which pushes the internal dimensions to 84cm) and then converts to a round threaded section to allow air conditioning piping or equivalent to be attached.

25 to 40 expansion

This is another model I put together while building up a solution similar to https://www.printables.com/model/146367. I was not able to find the 40mm pipe required and so needed to make a 25mm pipe that I had on hand, fit without the spools losing height in the box.

The half moon shape, when sitting with the opening upward, allows a 25mm pipe to side in a harness designed for a 40mm diameter pipe, while still meeting the same highest point.

Printing 2 at the same time:
- Layer height: 0.2mm
- Infill density: 10%
- Print time: 0h41m
- Total filament used: 3.035m

Print Station

Trending this Week

Categories

Trending

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Extraction Pipe Fitting

25 to 40 expansion