Extraction Pipe Fitting

This is potentially quite specific to a Weedo M2 (and potentially Weedo F150) 3D printer. There is a fan which extracts ait from the enclosed printer through a filter, but I wanted to have more control of where the output went. I therefore put this convert together which wraps around  an 80cm fan outlet (and its filter cover which pushes the internal dimensions to 84cm) and then converts to a round threaded section to allow air conditioning piping or equivalent to be attached.

25 to 40 expansion

This is another model I put together while building up a solution similar to https://www.printables.com/model/146367. I was not able to find the 40mm pipe required and so needed to make a 25mm pipe that I had on hand, fit without the spools losing height in the box.

The half moon shape, when sitting with the opening upward, allows a 25mm pipe to side in a harness designed for a 40mm diameter pipe, while still meeting the same highest point.

Printing 2 at the same time:
- Layer height: 0.2mm
- Infill density: 10%
- Print time: 0h41m
- Total filament used: 3.035m

Print Station

Most Popular of All Time

Categories

Popular

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Extraction Pipe Fitting

25 to 40 expansion