This is what I call a Filament Straightening Block. I designed it to straighten sections of filament to insert into 3D prints to act as axles or hinges.  I could instead design axles or hinges into prints but sometimes I want them thin AND strong. Using unprinted filament would provide both of those qualities...I just needed it to be straight.  Specifically, I used these for my recent project the Mini Magnetic Tile Haunted House Collection but plan to use it in other projects in the future also.

****3D Print Settings****
PETG preferred because of it's high heat tolerance (but PLA will work too:)
0.2mm Layer Height
20% Infill
No supports needed

Note: You will need two rubber bands to secure the two halves of the block together.  (I did design collars to the halves together which you could also use but I like prefer the rubber bands.)

To use this block, secure the two halves together with a couple rubber bands (or collar pieces).  Next heat a pot of water over the stove to around 160F (~70C) and carefully insert sections of filament into the hot water (please be careful not to burn yourself). Swirl the filament around until it gets soft (like a cooked noodle) and then insert it into one of the holes in the block, threading it all the way through.  Repeat (there are five holes) until filled.

Let the filament sit and set for a half an hour and then when you open it the sections will be straight:)

See the attached video to watch how I did it.

Have fun printing!

DOOR

Videos this Month

Categories

Videos

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Filament Straightening Block (Used to Straighten Unprinted Filament)